Tools & Supplies

Features:  For rip/crosscuts on wood. The large gullets allow deep cuts and effective chip clearance. Use on radial arm saws, miter saws, circular...

855.506.11 V-TONGUE AND GROOVE S=1/2''

Features:  Machines: radial arms, miter saws, table and special saws Material: chipboard, MDF, laminate, hardwood and plywood Carbide tipped Low ...

Features: Aggressive composition for faster material removal Innovative design for reduced noise Reduced vibration for superior user experience Hi...

Features: Power your most important nail and staple guns with the portable Rolair 1.5 HP air compressor 3400 RPM motor creates 4 CFM air pressure...

Features:  Each ratchet can be set for right- or left-hand operation—or locked to use the tool without it. Self-centering hardened steel jaws and...

Features:  Package of 24 Refills for #71262 and #81264 Grommet Kits Details:  Refill grommets for both #71262 and #81264 grommet kits.

Features:  SQUARE HEAD- Makes it possible to anchor the protractor against objects to hold it in place as you take measurements. MEASURES- Deeply...

Features:  Made of machined, fully polished and lacquered solid brass. Preferred by masonry, carpentry and surveying professionals. Conforms to ...

Features:  INSIDE, OUTSIDE AND SLOPED ANGLES - this plastic protractor/angle finder measures inside, outside and slope angles. FOUR PIECE STURDY ...

Features: Patent Pending tooth set design optimized to remove material faster Attached arbor and pilot drill included New side slot increased leve...

Features: Cuts machinable metals with shock-resistant bi-metal teeth Variable pitch blade Reduced vibration cutting Patent-pending tooth design...

Features: Rolair twin tank compressor 5715K17-0003 outputs 7.3-CFM at 90-PSI 1.5-HP motor operates at 1755 RPM with overload protection Heavy-du...

Features: Design for outdoor use Works with standard or arched frames Meets ANSI, CSA and OSHA standards Details: Metaltech scaffolding systems an...

Features: Sold on AmazonDetails: The VT20ST combines a low-noise and low-speed pump with a higher CFM output. This 4.2 CFM compressor delivers as m...

Features: 160 mm diameter Blade body thickness 2.2 mm Bore: 20 mm 56 Teeth Details: Technical features of the teeth tooth HW: - Height in mm: 6 ~...

Features: HEAVY DUTY HOLE PUNCH: A leather punch is designed for making holes in leather. The working tip is a hollow steel cylinder with a sharp ...

Features: Contains a 3-1/2-inch cove raised panel bit and a pair of 1-3/4-inch stand rail & stile bits Anti-kickback design, Non-Stick Orange ...

Features: Contains 3 flush trim bits featuring 3/8 and 3/4-Inch Diameter. 2 Hi-Density Carbide cutting edges for long-lasting performance. Equippe...