Tools & Supplies

Features: Rolair twin tank compressor 5715K17-0003 outputs 7.3-CFM at 90-PSI 1.5-HP motor operates at 1755 RPM with overload protection Heavy-du...

Features: Specs: Angle 45°, Minor Height 5/32" - 5/16", Minor Height 25/64", Overall Dia. 2-11/64", Overall Length 3-3/8", Shank Dia. 1/2", Small ...

Features: TiCo™ Hi-Density carbide specifically designed for each application to increase performance Perma-SHIELD® Non-stick Coating protects fro...

Features: Diablo made Dura-Carbide withstands impact and high heat applications, dramatically extending life versus standard hammer bits Precision...

Features: Diablo made Dura-Carbide withstands impact and high heat applications, dramatically extending life versus standard hammer bits Precision...

Features: Design for outdoor use Works with standard or arched frames Meets ANSI, CSA and OSHA standards Details: Metaltech scaffolding systems an...

Features: Designed with Hand Specific Tool Holders Padded Two Ply Tool Bags Keep Their Shape Extremely Abrasion Resistant Industrial Nylon Details...

Features: Sold on AmazonDetails: The VT20ST combines a low-noise and low-speed pump with a higher CFM output. This 4.2 CFM compressor delivers as m...

Features: 160 mm diameter Blade body thickness 2.2 mm Bore: 20 mm 56 Teeth Details: Technical features of the teeth tooth HW: - Height in mm: 6 ~...

Features: Contains a 3-1/2-inch cove raised panel bit and a pair of 1-3/4-inch stand rail & stile bits Anti-kickback design, Non-Stick Orange ...

Features: Contains 3 flush trim bits featuring 3/8 and 3/4-Inch Diameter. 2 Hi-Density Carbide cutting edges for long-lasting performance. Equippe...

Features: Each set includes interchangeable bearings and a wrench to cut multiple depths with a single bit. Great for furniture makers, cabinetmak...

Features: Each set includes interchangeable bearings and a wrench to cut multiple depths with a single bit. Great for furniture makers, cabinetmak...

Features: Adjusts in .004" or 1/250" increments. Features Premium TiCo™ HI-Density Carbide Crosscutting Blend for Maximum Performance. Silver I.C....

Features: Chip-free, flat-bottom dado cuts in veneer plywood, laminates, hardwoods, and softwoods. Set includes two outer blades, six chippers, Da...

Features: Premium TiCo™ Hi-Density carbide crosscutting blend for maximum performance Positive hook angles produce a smoother cut and allow for...

Features: For rip and crosscuts. The large gullets allow deep cuts and effective chip clearance. For radial arm saws, miter saws, table & spec...

Features: 1-1/8-Inch Diameter, 7/8-Inch Cutting Length, 1/2-Inch Minor Cutting Length, 2-13/16-Inch Length. Give a perfect shape for table legs an...

Features: Cost efficient fastener management. Single clip-on bags make it easy to switch to different applications. Keep them fully loaded and nea...

  Features: Premium quality super-strength steel. Spiral portion coating with black P.T.F.E. Extra-fine micrograin carbide spiral portion. 2 cu...

Features: Made of heavy-duty steel. 1/2-Inch Shank for 1/2-Inch collets. 3-15/32-Inch overall length. Details:  Steel-made router collet extensio...